17
3
2
1
1
Operating Instraction - DC545 HC
No. Item AF-100
1 Model Floor Model
2 Model No. AF-100
3 Input paper size Min.8.5” x 11” / A4
Max.12.6” x 18” / A3
<no curl in the paper>
4 Input paper weight Min.110gsm (29.3LB)
Max.230gsm (85LB)
5 Media type Range: Regular copy paper to coated heavy weight paper
6 Feeding method Automatic (Air suction method)
7 Feed tray capacity 3.9” (100mm)
8 Power supply DC5V, DC24V is supplied from DC-545 main body
9 Machine dimensions 43.4” (W) x 22.7” (D) x 37.8” (H)
1102mm (W) x 576mm (D) x 960mm (H)
10 Machine weight 117.1LB (Feeder : 44.9LB, Stand : 72.2LB)
53.2kg (Feeder : 20.4kg, Stand : 32.8kg)
11 Operating temperature 41-86F (5-30°C)
12 Operating Humidity 40-70% (no condensation within this range)
Troubleshooting table
Raise the elevator height by pushing the level adjustment
lever downward. (See Figure 1-1)
Lower the paper separators by turning the separator adjust-
ment knob clockwise, towards a lower number. (See Figure 2-1)
Increase the airflow by turning the airflow adjustment knob
counter-clockwise. (See Figure 3-1)
Lower the elevator height by pushing the level adjustment
lever upward. (See Figure 1-1)
Raise the paper separators by turning the separator adjustment
knob counter-clockwise, towards a higher number. (See Figure
2-1)
Decrease the airflow by turning the airflow adjustment knob
clockwise, towards a lower number. (See Figure 3-1)
1. Remove the paper from the feed tray.
2. Turn the skew adjustment knob according to the instruc-
tions on the label to adjust the angle of the feed guide.
The machine
does not feed
paper.
The machine
double feeds
paper.
The paper is cut
at an angle or
not fed straight.
Symptom Possible Cause Remedy
Paper level is too low.
Paper separators are too high.
Not enough airflow.
Paper level is too high.
Paper separators are too low.
Too much airflow.
The paper is skewed.
Specifications
Part Names and Their Functions
Docu Cutter(HC) 1_12-17 03.12.8, 3:09 PM17
To Next Page
Loading...
Need help?
General
