8
PC Controller Installation Procedures
Windows 8 / Windows 7 / Windows Vista
IMPORTANT
This section describes the procedures to install the PC Controller on the computer.
• Windows 8, Windows 7, and Windows Vista allow multiple users on one computer at
the same time.
Please be sure that only one user is logged in when installing the PC Controller.
• If you are requested to enter password of administrator account during installation of
the PC Controller, enter the password of the user with administrative rights shown.
• The following instructions use the screenshots appeared on Windows 8.
If you are using Windows 7 or Windows Vista, the screenshots vary.
• If you are using Windows 8, a SmartScreen warning
message may appear while installation is in progress.
Click [More info], and then click [Run anyway] to
proceed with the installation.
This software has been thoroughly tested and can be
used without any problems.
REFERENCE
REFERENCE
Make sure that the DC-616 is turned OFF.
Turn the computer ON to start the Windows.
Insert the CD-ROM that came with the DC-616 into your computer’s CD-ROM drive.
Auto Play screen appears.
Click [Open folder to view fi les].
The Auto Play screen does not appear on Windows
Vista.
A message appears in the top right corner of the screen.
Click the message.
The message does not appear except for Windows 8.
To Next Page
Loading...
