When the waste comes to approximately half of
the
waste box
, the DC-618 detects waste box
full.
If you select
MAX
on the
Waste Box Full
screen
in
System
, waste can accumulate until it comes
to about 70% of the waste box.
(For light weight documents and shorter
documents only)
(→ p.75 1. Waste Box Full)
Remove the waste in the
cut waste chute
section
indicated in the fi gure on the right.
(The right fi gure shows the inside of the
machine after the
waste box
was taken out.)
104
When a Document Jam Has Occurred
REFERENCE
Put the
waste box
back in its place and close the
front door
.
Make sure to set the
waste box
properly
pushing it all the way in.
Press the STOP key to clear the error.
The DC-618 is reset and the error message is
cleared.
IMPORTANT
IMPORTANT
To Next Page
Loading...
Need help?
General
