93
4
Troubleshooting
When a Document Jam Has Occurred
When a document jam has occurred, messages appear on the touch panel and an arrow
displayed there points at the position where the error is occurring in the fi gure of the machine.
Follow the procedures below to remove the jammed documents.
• Do not touch the tool. Doing so may cause injury.
• Before removing the jammed document, make sure that the machine is fully stopped.
Use tweezers or pliers to prevent your hands or fi ngers from being caught in the machine.
WARNING
J02 CHECK FEED TRAY
Too many documents are loaded on the
feed tray
.
Follow the procedures below to adjust the amount of
documents to proper one.
Press the
elevator down switch
to lower the
feed
tray
to the bottommost position.
Remove some documents so that the height of the
document stack does not exceed the
MAX
level.
1
2
3
J02- * CHECK FEED TRAY
Feed tray overloaded.
to clear
Elevator down switch
To Next Page
Loading...
Need help?
General
