110
Daily Maintenance
Daily Maintenance
Cleaning the Slitter Tool
Remove the
front guide
on the slitter module.
Reattach the
front guide
removed in step 1 to its
original position.
If a document is slit by the slitter after a long period
of use of the machine, fi nished products may get
dirty.
Before starting operation, clean the slitter tool with
an
air blower
, then perform test runs several times
and check the fi nished products to make sure that
there is no blot on them.
Cleaning the Sensors
Front
guide
Top cover
Open the
top cover
.
To Next Page
Loading...
