Duplo DC-618 - Processing a JOB in Pause Feeding Mode

65
3
Basic Operations
Processing a JOB in Pause Feeding Mode
When the DC-618 enters the
pause feeding mode
,
the
feed tray
rises and stops with its level kept.
Pressing and holding the START key during the
operation enters the
pause feeding mode
.
REFERENCE
REFERENCE
Make sure that the
standby
screen is displayed on
the
touch panel
.
Press and hold the START key.
The DC-618 enters the
pause feeding mode
.
7



6(7
7



6(7
Press the START key in the
pause feeding mode
.
The DC-618 restarts operation.
This section describes how to process a JOB in the
pause feeding mode
.
Use this mode when you want to stop processing documents temporarily for checking the fi nished
products and adjusting
Blow Fan
.
REFERENCE
1. You can adjust air level for
Blow Fan
.
Touch the / icon or the
slider
to adjust the
value for
Blow Fan
.
The larger the value is, the higher the air level
becomes. The smaller the value is, the lower the air
level becomes.
+
-
2. If you adjust the air level, the fi gure on the right
appears when the JOB processing has fi nished.
To save the setting adjusted, touch
YES
. If not,
touch
NO
.