92
When Messages Appear
Message Status and Solution
SLOT WRONG
Slot3 Slot2 Slot1
Modules OK Slit OK
to clear
Status: The module installed does not match a JOB to be
processed.
Solution: Check if the module in the slot displayed in a
red frame on the touch panel matches the one
installed in the machine. Install the module
indicated in the read frame. Then press the
STOP key to clear the error and start operation
over again.
(The left display is an example. It differs
depending on specifi cations. A different module
is installed in slot 2 although the JOB needs a
slitter module there.)
The gutter slit wastes come out on the
stacker.
** to continue
Status: A JOB ejecting gutter slit wastes was processed
with
Read Barcode
in
Process
set to
OFF
.
**: Displays an icon of the key pressed when
processing of a JOB was started.
Solution: Press the key of the icon displayed in ** to
continue the JOB processing.
When the JOB processing is continued, the
gutter slit waste is not ejected to the waste box
but is ejected to the
exit tray
.
The gutter slit wastes come out on the
stacker.
to clear
Status: A JOB ejecting gutter slit waste was processed
when the DC-618 reads a barcode with
Read
Barcode
in
Process
set to
All
or
Only First Sht
.
Solution: Press the STOP key to clear the error.
Check the JOB detail.
To Next Page
Loading...
