52
List of Messages
Message
Cannot enter Gutter Slits.
Cannot enter Gutter Cuts.
The above job name is invalid.
Communication Error (001) – (***)
Communication Error (002) – (003)
Communication Error (004)
File I/O ERROR
Countermeasure
Cannot input gutter slit since the number of page layout in the horizontal-
direction is either 1 or more than 4.
Cannot input gutter cut since the number of page layout in the vertical-
direction is 1.
The JOB name contains a character that cannot be used.
The JOB Creator cannot recognize the DC-645.
Check the following.
1. Is the USB cable securely connecting the computer and DC-645?
(a P.18 “How to Connect the DC-645 to your Computer”)
2. Is the DC-645 turned ON?
3. (Macintosh OS9): Is the USB driver copied in the [Extensions] folder in
the [System] folder? Check to see if its use has been turned OFF?
(a P.32 “Installing Procedures” (Macintosh)].
4. (Macintosh OSX): Is a Classic environment launched?
5. (Windows): Is [USB DC-645 Ver*.*] registered as a USB controller in
the [Device Manager] dialog?
(a P.30 “Installing Procedures (Windows)”)
6. Is the USB cable shorter than 3 meters?
Communication Error occurred.
1. Restart the DC-645 and computer.
2. Is the USB cable shorter than 3 meters?
Communication error occurred with DC-645 while the DC-645 and the
computer was communication, showing a “Busy / Error / Jam Warming”.
Check the LCD panel for the Error display. Correct the Error, JAM and/or
Warning according to the procedures described in “Error Display” (P.80),
“Warming Display” (P.82), and “When a Paper Jam Has Occurred” (P.83 –
99).
Retry communications after that.
(Windows) Illegal file path. Check the correct file path.
To Next Page
Loading...
