89
25
Troubleshooting
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the <JOG> key and eject the jammed
document to the stacker tray side.
When a Paper Jam Has Occurred
––– J 4 –––
CUTTER OR CREASE
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Open the top cover 3.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the <STOP> key to reset the fault logic
and clear the message.
When “CUTTER OR CREASE” is Displayed
If a paper jam has occurred in the cutter or creaser module, “CUTTER OR CREASE” is displayed on the LCD
panel and the lamp blinks on the OK monitor.
Remove the jammed document with the following procedure.
123
456
789
C
0
123
456
789
C
0
■ If the document cannot be removed with the procedure mentioned above
When uninstalling the creaser module:
Continue Page
•••
To Next Page
Loading...
