55
1
3
Programing JOB for DC-645 on Control Panel
AUTO CUT
Paper area before first cut and after last cut, and area between 2 cuts which is 20 ā 84.99 mm long, are considered to be
waste and will be chopped up for disposal in waste box when AUTO CUT is enabled.
Definition of Programming Terms
Example 1 - When AUTO CUT must be OFF
Example 2 - When AUTO CUT must be OFF
When documents do not have lead or trail margin, (as in the example 1 and 2 below), make certain to turn OFF the
AUTO CUT feature.
Leading edge of the paper
First Cut
Last Cut
When the distance between two cuts
arre 20 ā 84.99 mm long, they will be
chopped up for smooth disposal into the
waste box.
Area where automatic
cutting can be done
To Next Page
Loading...
