6. ERROR MESSAGE and TROUBLE SHOOTING
Possible Cause and Solution
E001 S1 Jam Sensor Error 1. Paper wrap around the roller
2. Use to remove the paper
3. Slow down the coating speed, or
4. Change paper feeding direction
E002 S2 Input Sensor Error
Use to move the paper forward or
E003 S3 Conveyor Sensor Error 1.
Conveyor driving belt broken
2. Conveyor has problem
3. Conveyor Motor Drive has malfunctioned
1. Remove the paper on Exit Sensor
2. Sensor has a problem
3. Bridge plate right after the coating roller, has
restricted the coated paper from moving
smoothly. Open the UV hood to clean the plate.
4. Call for service
E005 S5 UV Hood Sensor Error 1.
UV Hood is not in position
2. UV Hood Sensor has malfunctioned
E006 S6 Safety Cover Error 1. Lock the safety cover in position
2. Sensor has malfunctioned
1. Reset Emergency Stop Switch
2. Emergency Stop has malfunctioned
To Next Page
Loading...
Need help?
General