Duplo ULTRA 200PRO User Manual

45
3. Scraper blade damaged
4. Coating gap too small
5. Operation procedure not
followed
3. Call for service
4. Call for service
5. Refer to the manual
Paper has a little
bit coating or it
cannot be
trasport forward
1. The applicator roller is not
setting to “0000”
1. Set Auto Gap to OFF
2. Set the applicator roller to “0000” then set Auto
Gap to ON
Smearing in the
bottom image of
closs to
operation side
Pumping speed set to Sp-3 causing
varnish splashing onto feed bridge
plate
Reduce pump speed to Sp-1 or Sp-2

Duplo ULTRA 200PRO Specifications

General

Brand	Duplo
Model	ULTRA 200PRO
Category	Printer
Language	English