Mounting the complete thread catcher
–
Mount the complete thread catcher on the machine head.
–
Mount the complete thread catcher in such a way that the needle
thread catcher 3 is centric between the needles.
–
Adjust the height of the thread catcher so that the dimension
between sliding sheet and lower edge of the needle thread catcher
is 27 +/- 1 mm.
–
Putontheknifeprotection8.
The knife protection 8 has to be adjusted in such a way that the
distances of 1 mm and 0.5 mm are kept when the center knife is in
the lower dead centre.
–
Tighten the knife protection 8 with screw 7.
42
To Next Page
Loading...
