Raising the machine head
–
Remove the covering cap 1.
For this purpose lift the covering cap at the front and at the back so
that the arrest is released. Lift the covering cap carefully.
–
Swivel the folding station 3 out by 90°.
–
Swing the locking peg 4 upwards.
–
Lift the fabric sliding sheet 6 at the front and swing it to the left.
–
Lift the machine head in the area of head cover 5 and raise it
carefully.
Pawl 2 snaps in additionally.
The area underneath the machine table is accessible for cleaning.
Caution: Danger of injury !
Do not reach into the table top cutout when the machine head is
raised.
Sw inging the machine head back
–
Hold the machine head in the area of head cover 5.
–
Release pawl 2.
–
Swing the machine head back carefully.
Attention: Danger of breakage!
Hold the machine head tight until it finally rests on.
–
Insert the fabric sliding sheet
–
Swivel the locking lever 4 downwards.
–
Swing the folding station 3 back carefully and let it catch in the
locking lever.
–
Put on the covering cap 1 and let it snap in again.
7
2
To Next Page
Loading...
Need help?
General
