3.2 Saving and loading the language version
3.2.1 Transferring the language version from the memory card to the controller
CAUTION:
The machine must not be switched off during the transfer of data to the
controller.
–
Turn on the main switch, press and hold down the “á” key
or
press the “RST” and “á” keys.
–
The “language-selection” screen appears.
–
Insert the memory card sideways into the controller in the direction
of the arrow.
–
Use the “ñ ”or“ò” cursor keys to select the required language
version.
–
Press the “F5” key.
The language transfer begins.
When transfer is complete OK appears on the screen.
–
Remove the memory card.
–
Turn the main switch on and off
or
press the “RST” key.
The unit starts with the new language version.
NB:
In the course of a program update the default language, English, can
be restored with the key.
8
To Next Page
Loading...
