DURKOPP ADLER 745-34 - CAN Test

Output elements feed unit
Output Function Insertion method
element ABDF
Y03 close left folding plate X X X
Y04 open left flap clamp XXXX
Y05 close right folding plate X X X
Y06 open right flap clamp XXXX
Y09 lower left feed clamp XXXX
Y10 left slide outwards XXXX
Y11 lower right feed clamp XXXX
Y12 right slide outwards XXXX
Y13 vacuum on XXXX
Y15 lower folder XXXX
Y16 lift out folder XXXX
Output elements blade-bracket unit
Output Function Insertion method
element ABDF
Y17 seam-start blade-bracket left XXXX
Y19 seam-end blade-bracket left XXXX
Y21 seam-start blade-bracket right XXXX
Y23 seam-end blade-bracket right XXXX
6.4.6 CAN test
Press OK to run the test program.
Hint:
CAN modules work with no errors.
Displaying the OK message takes some considerable time.
83