6.3.2 Initialising memory
The program loads a standardised factory setting for the
sewing-program parameters,
e.g. for a new controller:
Info line:
Initialising memory
CAUTION:
Once one of these three programs has been run the parameters set
are overwritten with a standardised factory setting.
For this reason this program section can only be run after the entry of
code number “25483”.
–
Press OK to run the test program.
The code-number entry box appears in the display.
–
Enter code number “25483” on the decimal keypad.
Once the correct code number has been entered the display
switches to the four parameters listed below.
If an incorrect code number is entered the display switches to the
machine-specific parameter screen.
Initialising the machine parameters
Initialising pocket programs
Initialising pocket sequences
Initialising all programs and parameters
Hint:
After initialisation the machine parameters (RST + F1) must be
rechecked.
50
Code
To Next Page
Loading...
