DURKOPP ADLER 745-34 - 7.3 Step-motor error messages; 7.4 CAN-Module error messages

6.8 Adjusting the serial interface ( + )
This test program sets the correct transfer speed (baud rate) for the
serial interface.
The correct baud rate for the serial interface is:
Com0=n,8,WA,1-125K Baud
CAUTION:
If the machine is switched on with one of the following keys pressed,
baud rates incompatible with the operating panel of the controller will
be set:
key “0"
key ”1"
key “2"
key ”3"
key “4"
key ”5"
key “6"
key ”7"
key “8"
key ”9".
89