3.3 Transferring the machine software to the controller
The machine software is transferred to the controller by means of a
“bootbox” or a notebook and loader cable.
The connection and operation of the bootbox are described in the
“Bootbox for manual and automatic sewing machines
with DAC2A/B controllers”
operating instructions, part no. 0791 100621.
The connection and operation of the notebook and loader cable are
described in the
“Loader cable for DAC2A/B controller”
operating instructions, part no. 0791 100622.
3.4 Changing the memory-card battery
Memory-card retention period with no change of battery: approx. 4
years.
CAUTION:
Programs stored on the memory card will be erased when the battery
is changed.
Load programs into a controller before changing the battery.
9
To Next Page
Loading...
