DURKOPP ADLER 745-34 - 5.6 Pocket sequence (F2)

5.5 Blower mode
Entry:
0, 1, 2, 3, 4. 5. 6, 7
Valve YC101 Valve YC105 application
Position blowing on blowing off Position blowing on blowing off
Mode 0 - active - active function off
Mode 1 blower pipe
in flap
clamps
flap clamps
closed
needles on blower pipe
in the folding
sheet
folding sheet
closed
needles on needles on
Blow pocket bag
and/or piping to
the seam
beginning
simultaneously
Mode 2 blower pipe
in flap
clamps
flap clamps
closed
needles on blower pipe
in the folding
sheet
folding sheet
closed
needles onneedles on flap clamp
closed
Blow pocket bag
and piping to the
seam beginning
alternately
Mode 3 blower pipe
in flap
clamps
flap clamps
closed
10 mm after
the loading
position
blower pipe
in the folding
sheet
Stemp sink
up
10 mm nach
Einlege-
position
Shortly blow
pocket bag
and/or piping
simultaneously.
Blow piping
during the
lowering of the
stamp already
Mode 4 blower pipe
in flap
clamps
flap clamps
closed
needles on blower pipe
in the folding
sheet
Stamp sink
up
flap clamp
closed
Blow pocket bag
and piping to the
seam beginning
alternately. Blow
piping during the
lowering of the
stamp already
Mode 5 Short
blower pipe
in left flap
clamp
5mmafter
the loading
position
needles on blower pipe
in right flap
clamp
flap clamp
closed
needles on
Blow pocket bag
on flap
Mode 6 blower pipe
in flap
clamps
flap clamps
closed
needles on blower pipe
in the folding
sheet
folding sheet
closed
180 mm
nach Ein-
legeposition
Blow pocket bag
and/or piping
simultaneously.
Blow piping after
path.
Mode 7 blower pipe
in flap
clamps
10 mm after
the loading
position
180 mm
after the
loading
position
blower pipe
in the folding
sheet
20 mm after
the loading
position
180 mm
nach Ein-
legeposition
Blow pocket bag
and/or piping
after paths.
36