DURKOPP ADLER 745-34 - Page 4

Contents page:
6.3.5.5 Corner-blade machine parameters................................... 64
6.3.6 Testing needle and centre-blade activation.............................. 66
6.3.7 Checking the tape feed ......................................... 67
6.3.8 Checking the gripper folder without feed clamp (versions B and F only) ............ 68
6.3.9 Checking the insertion process with feed clamp ........................... 69
6.3.10 Step-by-step mode ............................................ 70
6.3.11 Determining the cycle time ....................................... 71
6.3.12 Checking and adjusting the piping knives............................... 72
6.3.12.1 Checking the piping knife motion.................................... 72
6.3.12.2 Setting the piping knife reference position .............................. 73
6.4 Multitest system .............................................. 74
6.4.1 Displaying the program version and check sum ........................... 75
6.4.2 Testing the RAM .............................................. 76
6.4.3 Selecting input elements......................................... 77
6.4.4 Checking input elements ........................................ 79
6.4.5 Selecting output elements ........................................ 80
6.4.6 CAN test .................................................. 83
6.4.7 Checking the sewing drive ....................................... 84
6.4.8 Error list .................................................. 85
6.5 Terminal self-test ............................................. 86
6.6 Display contrast value .......................................... 87
6.7 Editing the menu ............................................. 88
6.8 Adjusting the serial interface ...................................... 89
7. Error messages
7.1 Machine-program error messages ................................... 90
7.2 Sewing-motor controller error messages ............................... 90
7.3 Step-motor error messages ....................................... 91
7.4 CAN-Module error messages ...................................... 91
7.5 System error messages ......................................... 92