Input Function Insertion method
element ABDF
S01 Flap scanning 1 XXXX
S02 Flap scanning 2 X X X
S03* Residual-thread monitor right XXXX
S04* Residual-thread monitor left XXXX
S05 Needle-thread monitor right XXXX
S06 needle-thread monitor left XXXX
S10 Right pedal forward XXXX
S11 Right pedal back XXXX
S13 Left pedal forward XXXX
S15 Left pedal back XXXX
S16 Blade-bracket monitoring XXXX
S17 Folder down XXXX
S18 Folding station swung in XXXX
S20 Remove material / XXXX
cover monitoring
S22 Simple piping right X X X
S23 Simple piping left X X X
S24 Pressure monitor XXXX
S25 Feed-device reference XXXX
S26 Seam-start corner-blade reference XXXX
*) Input elements can only be tested by means of the test program 6.3.1 “Adjusting the
looper-thread monitor”
Input elements CAN node 0
Input Function Insertion method
element ABDF
SC001 Folder on top X X
SC002 Folder on piping table X X
SC003 Folder vertical X X
SC004 Folder inclined X X
Input elements CAN node 2
Input Function Insertion method
element ABDF
SC201 seam-start blade-adjustment reference XXXX
SC203 seam-end blade-adjustment reference XXXX
Input elements CAN node 3
Input Function Insertion method
element ABDF
SC301 Ref. Piping knife adjustment X X
78
To Next Page
Loading...
