Error number Meaning Remedy
Error 900 Defective machine parameters
(check-sum error)
Re-initialise machine parameters
(test program); adjust machine parameters
or read them in from the RAM card
Error 901 Defective pocket sequences
(check-sum error)
Re-initialise pocket sequences (test
program); adjust pocket sequences or
read them in from the RAM card
Error 902 Defective pocket programs
(check-sum error)
Initialise defective pocket programs (test
program); adjust pocket programs or read
them in from the RAM card
Error 910 RAM card not correctly plugged in Plug RAM card in correctly
Error 911 RAM card is write-protected
Remove RAM-card write-protection
Error 912 RAM-card read or write error
Rreplace RAM-card battery; data must
then be saved to the RAM card again
Error 913 No language RAM card for class
745-34 plugged in; RAM-card type
is wrong.
Plug in language RAM card for class
745-34
Info 1000 Reminder to execute the reference
run after switching on
Push left pedal backwards
Info 1001 Corner-blade station is swivelled
out
Swivel corner-blade station in
Error 1001 Corner-blade station swivelled out
during sewing.
Push left pedal backwards: the feed
carriage moves backwards and a
reference run is executed.
Check/adjust corner-blade station
attachment
Info 1002 Folder station swivelled out
Swivel folder station in
Error 1002 Folder station swivelled out during
sewing.
Push left pedal backwards: the feed
carriage moves backwards and a
reference run is executed.
Check/adjust folder station attachment
Info 1003 Tape is missing
Insert tape
Info 1004 The adjusted position for the feed
clamp does not fit the built-in
stamp.
Adjust the position of the feed clamp to
match the one displayed in the pocket
parameters.
Info 1005 Incorrect setting of the flap
scanning.
Correct the pocket program.
93
To Next Page
Loading...
