3.2 Assembling the table top
3.2.1 Assembling the table top in the machine with the direct drive
–
Turn the table top (1) upside down.
–
Screw the drawer (2).
–
Put the oil tank (3) on the recess in the table top and slide it in the
arrow direction (4) till the relevant protrusions of the tank are
seated on the recess contour. Screw the tank.
–
Screw the pedal position senzor (5).
–
Screw the sewing lamp transformer (6) – if there is any.
–
Screw the cable clip (7).
–
Screw the electric cable channel (8).
–
Mount electric cables according to par. 5 of this instruction.
–
Pre-bore the holes (9) for wood screws and screw the stand frame.
Then turn the stand to normal position.
–
Mount the yarn s tand (10) with the bar orientation according to the
picture.
–
Insert the machine head support pin (11) - the machine with edge
trimming..
–
Screw the rubber hinge bottoms (12).
–
Insert the rubber corners (14).
–
Remove the blinds from the bushing (15).
–
Dismantle the knee lever (16) and push it through the bushing (15)
according to the picture.
5
EN
15
35
80
328
800
40
90
205
15
368
80
15
79 8 85 4 3
1
2
11
14
10
260
12
15
16
460
185
103
70
5
6
To Next Page
Loading...
