4 Assembling the machine head
4.1 Fitting the machine head
–
If the sewing machine is equipped with a motor on the table top,
insert the machine head (1) vertically in the recess in the table top.
–
If the sewing machine is equipped with a motor (drive) on the
machine head, tilt the machine head (2) and insert it in the table
top recess.
–
After the head insertion, screw the locking plate (3) immediately to
secure the machine head against falling out at its tilting.
The locking plate is part of the machine head accessories.
10
1
2
3
To Next Page
Loading...
