DURKOPP ADLER 887 Series - Winding the Hook Thread

6.2 Winding the hook thread
–
Thread the thread according to the picture.
–
Insert the thread under the knife (1) and tear off by pulling in the
arrow direction (2).
–
Fix the bobbin and press the lever (3) in the direction (4).
–
Start the machine up.
–
After the thread winding, slide the thread under the knife again (1)
and tear it off.
–
Insert another bobbin immediately and press the lever (3).
6.3 Inserting the bobbin and threading the hook thread
Caution! Risk of injury!
Switch the main switch off and wait till the motor stops.
–
Tilt the shutter (1) up.
–
Insert the bobbin (2) with the thread end (3) oriented according to
the picture.
–
Thread the thread through the slit (4) and space (5), hook upon the
shutter (1) and fasten it under the spring (6).
–
Trim the thread ends according to the picture.
–
If the hook is located to the left of the needle, fix the bobbin and do
the threading in a similar way.
16
1234
2
3
6
1
4
5
10