5.4 Connection of machine head electric equipment to drive
A. The machine is equipped with the DAC basic/classic drive
–
Connect the sewing head connection cable into the connector (1)
signed with the machine symbol.
–
Connect the control panel into the connector (2) signed with the
panel symbol.
–
Connect the motor encoder connector into the connector (E).
–
Connect the motor c onnector into the connector (M).
–
Connect the pedal position sensor into the connector (3) signed
with the pedal symbol.
–
Connect “machine identification” into the connector ID.
–
Connect the proximity switch to the connector (SYNC) if the sewing
machine has a gear ratio different from 1:1.
–
The connector (4) is used for the connection of other peripheries,
e. g. a k nee lever or an electric hand wheel.
19
EN
E
2
3
ID
M
SYNC
4
1
To Next Page
Loading...
