DURKOPP ADLER 887 Series - Fitting the Knee Lever and Oil Pump Pipe

4.4 Fitting the knee lever and oil pump pipe
–
Lift the sewing foot with the hand lever.
–
Tilt the machine head (1).
–
Slide the shaft ( 3) in the lever (4).
–
Screw the screw (5) with the washer (6) in the shaft ( 3).
–
Attach the pipe (7) with the clips (8) and install the suction
basket (9).
–
Tilt the machine head and adjust the knee lever (10) according to
the picture.
–
Adjust the knee pad.
13
EN
10°± 5°
10
1
8
9
7
4
6
5
3