B. The machine is equipped with the Efka DA321G drive
–
Pull the network plug out of the socket.
–
Screw out 4 screws on the front panel of the control box.
–
Dismantle the front panel.
–
Pull the transformer cable through the channel (1) in the control
box.
–
Remove the black rubber bushing (2).
–
Pierce the bushing with a screwdriver.
–
Pull the sewing lamp transformer cable through the arisen hole.
–
Insert the rubber bushing back again.
–
Press the clip openers (3) and (4) with a small screwdriver slightly
until the clips (5) and (6) open.
–
Connect the blue conductor to the terminal (6) and the brown
conductor to the terminal (5).
–
Screw the front panel back again.
17
EN
26 5 1
65 4 3
To Next Page
Loading...
