Dymo XTL 500 - Changing the Settings; Changing the Language; Changing the Units of Measure; Changing the Screen Brightness

39
XTL
™
500
User Guide
Changing the Settings
You can change the following settings:
 Changing the Language
 Changing the Units of Measure
 Changing the Screen Brightness
 Changing the Auto Shut-off Time
 Changing the Recall Data Setting
 Setting the Print Options
 Setting the Default Barcode
All settings remain in effect until you change them again.
You can also restore certain factory settings:
 Restoring the Label Application Default Settings
 Restoring Factory Default Settings
Changing the Language
Changing the language setting only affects the text and menus in the display.
To change the language
1 From the Home screen, tap and select Language.
2 Select a language and tap Done.
The language is changed immediately.
Changing the Units of Measure
You can choose to work in millimeters or inches. The default unit of measure is
inches.
To change the units of measure
1 From the Home screen, tap and select Units of measure.
2 Select the Inches or mm and tap Done.
Changing the Screen Brightness
You can change the brightness of the screen to accommodate different lighting
situations.
To change the brightness
1 From the Home screen, tap and select Screen brightness.
2 Drag the slider left or right to select the brightness level you desire and tap
Done.