Dynamatic EC 2000 - Standard NEMA Rated Enclosure Dimensions; Mounting Hardware

46 pages

To Next Page

To Previous Page

Figure 6: Standard NEMA Rated Enclosure Dimensions (Not to Scale)

5.1 Mounting Hardware

• Standard Panel

o ¼” - 20 Bolts, Flat Washers, Lock Washers (Not included)

• Standard Enclosure

o ¼” - 20 Bolts, Flat Washers, Lock Washers (Not included)

• Keypad

o Included

Main Page

Default Chapter2
- Table of Contents2
Figure 1: Eddy Current Drive & Control Block Diagram5
Section 1 - THEORY of OPERATION5
Figure 2: EC 2000 Keypad Display6
Section 2 - SPECIFICATIONS7
- Features7
- Power and Load Ratings7
- Electrical Protection7
- Environmental Ratings8
- Electrical Noise8
- Enclosures8
- Weight8
- Dimensions8
- Reliability8
- Codes and Standards8
Section 3 - CONTROL OPERATION MODES9
- Control Modes9
- Other Modes of Operation9
Section 4 - INPUTS/OUTPUTS10
- Analog Inputs10
- Digital Inputs10
- Analog Outputs10
- Digital Outputs11
Figure 3: Standard Panel Dimensions12
Section 5 - INSTALLATION12
- Figure 4: Keypad Cutout Template13
- Mounting Hardware15
- Figure 9: Setpoint Reference & Manual/Auto Mode Wiring17
- Figure 8: Start/Stop/Jog & E-STOP Wiring17
- Figure 7: “TB1” Terminal Block17
- Figure 10: Programmable Analog Outputs Wiring18
- Figure 11: Current Transformer Wiring for Torque Limiting18
- Figure 12: Preset Speeds and PLC Run Wiring19
- Figure 13: Speed Pickup Wiring19
- Hardware Setup20
Figure 14: Relay 1-4 Connection Diagram20
Table 1: EC 2000 Jumper Settings20
Table 2: Follower Setpoint Jumper Settings21
Table 3:Torque Limiting SW1 Settings21
Table 4: Keypad Button Descriptions22
Section 6 - KEYPAD22
- Table 5: Mechanical Unit Tach Pulses/Rev Setting23
- Menu B: Clch Performance28
- Menu C: Accel/Decel Setup29
- Menu D: Brake Performance29
- Menu E: Follower Setup30
- Menu F: Analog Outputs31
- Menu G: Relay Output32
- Menu H: Units33
- Menu J: Potentiomtr Setup34
- Menu K: Source Select34
- Menu L: Process36
- Menu M: Fault36
- Menu N: Auto Restart39
Section 7 - PROGRAMMING23
- Menu A: Control Setup23
Section 8- Troubleshooting40
- Control will Not "Run" or "Start40
Section 9 - ETHERNET IP and SERIAL COMMUNICATIONS42
- Data Transceiving Organization42
- Read and Write Requests42
- Notes42
- Data Acquisition43
Table 6: Ethernet Ip/Serial Data Acquisition43
Section 10 - INDEX44

Dynamatic EC 2000 - Standard NEMA Rated Enclosure Dimensions; Mounting Hardware

Table of Contents