7.8 Menu H: UNITS
1. PROCESS UNITS
• RPM (default)
• PERCENT (used for torque mode)
• USER
USER can be selected to display speed in something other than RPM. If chosen, Parameters
2-4 are opened for changing. If not, Parameter 1 is the only one that is open.
2. USER UNITS
• RPM (revolutions per minute)
• RPS (revolutions per second)
• RPH (revolutions per hour)
• CPM (cycles per minute)
• CPS (cycles per second)
• CPH (cycles per hour)
• FPM (feet per minute)
• FPS (feet per second)
• FPH (feet per hour)
• SPM (strokes per minute)
• SPS (strokes per second)
• SPH (strokes per hour)
• XPM (x per minute)
• XPS (x per second)
• XPH (x per hour)
3. USER DECIMAL PNT
• 0 (no decimal)
• 1 (one decimal)
• 2 (two decimal)
• 3 (three decimal)
4. MAX USER VALUE
Enter the number of user units that corresponds with the top process speed. For example, if
the maximum press speed is 40 SPM, the MAX USER VALUE will be 40.0 (USER DECIMAL PNT
will be 1).
To Next Page
Loading...
Need help?
General