7.13 Menu N: AUTO RESTART
1. RESTART POWER EN
If enabled, the control will start and enter run mode right after power is applied.
• ENABLE
• DISABLE (default)
2. RESTART FAULT EN
If enabled, the control will restart and enter run mode again after a fault.
• ENABLE
• DISABLE (default)
3. START DELAY- PWR
The delay timer for auto start on power up (default: 10 sec)
4. START DELAY- FLT
The delay timer for auto start after a fault (default: 10 sec).
5. MAX FAULT RETRYS
The number of attempts allowed to restart after a fault.
6. RESTART TIMER
The timer that determines when to clear the start attempts counter. For example, if the
parameter was set to 60 sec, then the drive will have to run for 60 seconds before the start
attempts are cleared.
To Next Page
Loading...