SECTION 3 – CONTROL OPERATION MODES
3.1 Control Modes
• Speed (AC Tachometer Generator or Pulse Pickup)
• Torque (Current Feedback)
• Speed/Torque (switchable)
3.2 Other Modes of Operation
• Local/Remote
o Allows the user to switch between keypad use and externally wired devices
• Jog
• Manual/Auto
o Allows the use to switch between an automatic signal (i.e. 4-20mA or 0-10V) and
the control potentiometer
• 2 or 3 wire start/stop
• Four Preset Setpoints
o Programmable through the keypad
• PLC Run
• Auto Start on Power
• Auto Restart after fault
• Adjustable Braking
• Coast to Stop
• Ramp Control
• Loss of Follower
• Torque Limit
o Requires motor current transformer
• User Process Units
• Forward/Reverse Speed Control
• ESTOP (TB2-31 and 32 are not closed)
To Next Page
Loading...