7.11 Menu L: PROCESS
Match minimum and maximum values to previously set values for minimum/maximum
speed.
1. MINIMUM PROCESS
2. MAXIMUM PROCESS
3. PRESET 1
The setpoint for “P1”.
4. PRESET 2
5. PRESET 3
6. PRESET 4
7. JOG SETPOINT
The setpoint for “JOG”.
7.12 Menu M: FAULT
1. CURRENT FAULT
Allows the user to see the current fault (read only).
2. PRIOR FAULT #1
Allows the user to see the previous fault (read only).
3. PRIOR FAULT #2
Allows the user to see the second previous fault (read only).
4. PRIOR FAULT #3
Allows the user to see the third previous fault (read only).
5. PRIOR FAULT #4
Allows the user to see the fourth previous fault (read only).
6. CLEAR FAULT
If enabled, the control will clear the fault history.
• ENABLE
• DISABLE (default)
To Next Page
Loading...
Need help?
General