7.9 Menu J: POTENTIOMTR SETUP
The setup menu if an external potentiometer is used for a setpoint reference.
1. POT MINIMUM
2. POT MAXIMUM
3. POT MINIMUM REF
4. POT MAXIMUM REF
7.10 Menu K: SOURCE SELECT
The setup menu for run, jog, presets, stop, start, and setpoint reference modes. “TERM” refers
to devices attached to TB2, “KEYPAD” refers to operation from the Keypad. Remember, for
external devices to be functional, the control must be in “REMOTE.”
1. AUTO/MAN SOURCE
• TERM
• KEYPAD
2. JOG SOURCE
• TERM
• KEYPAD
3. PLC AUTOSTART
Allows the user to automatically start the control using the PLC start input terminals (TB2-28
and TB2-27) instead of the normal start terminal of TB2-23. By enabling and closing TB2-28
and TB2-27, the drive will automatically start upon power up. Note: the next parameter, “PLC
RUN ENABLE”, must be enabled as well.
• ENABLE
• DISABLE (default)
4. PLC RUN ENABLE
Allows the user to start or stop the drive based on the PLC start input terminals of TB2-28 and
TB2-27.
• ENABLE
• DISABLE (default)
To Next Page
Loading...