21CA 150 M150EN2
EVERY 500 OPERATING HOURS (Every three months)
Fig. 27 Engine
1. Screw
2. Glass bowl
3. Filter
Fuel pre-filter – Cleaning
Place the roller on a level base. The engine
must be switched off and the parking brake
applied for all checking and adjustments
on the roller unless stated otherwise.
Loosen the screw (1) and remove the bowl (2).
Take out the strainer (3) and clean using a non-
flammable fluid. Reinstall the strainer and the bowl.
Start the engine and check that the pre-filter does not
leak.
Make sure there is adequate ventilation
(extraction) if the diesel engine is run in-
doors. Risk of carbon monoxide poisoning.
2
1
WARNING
WARNING
3
To Next Page
Loading...
Need help?
General
