Dynapac CA150D User Manual

3CA 150 M150EN2
LUBRICANTS AND SYMBOLS
ENGINE OIL Shell Universal SAE 15W/40 or equivalent
API Service CF-4/SG, (CD/CE)
HYDRAULIC FLUID
ambient air temperature Shell Tellus Oil TX68 or equivalent
-10°C – +40°C (14°F - 104°F)
ambient air temperature Shell Tellus Oil TX100 or equivalent
above +40°C (above 104°F)
BIODEGRADABLE Shell Naturelle HF-E46
HYDRAULIC FLUID When it leaves the factory, the machine may be filled
with biologically degradable fluid. The same type of
fluid must be used when changing or topping off.
TRANSMISSION OIL
ambient air temperature Shell Spirax SAE 80W/90, HD API, GL-5
-15°C – +40°C (5°F - 104°F)
ambient air temperature Shell Spirax HD85W/140 or equivalent
above +40°C (above 104°F)
DRUM OIL
ambient air temperature Shell Spirax SAE 80W/90, HD API, GL-5
-15°C – +40°C (5°F - 104°F)
ambient air temperature Shell Spirax HD85W/140 or equivalent
above +40°C (above 104°F)
GREASE SKF LGHB2 (NLGI Class 2) or equivalent for
articulated joint. Shell Retinax LX2 or equivalent
for other lubrication points.
FUEL See the engine manual
COOLANT Shell Anti-Freeze 402 or equivalent
mixed 50/50 with water Anti-freeze protection down to about -35°C (-31°F).
50
/
50
Always use high-quality lubricants, in the quantities specified. Excess grease or oil can
promote overheating, resulting in premature wear.
When driving in extremely high or low ambient tempe-ratures, other lubricants are needed.
Refer to the chapter entitled “Special Instructions” or contact Dynapac.
Engine, oil level Tire pressure
Engine, oil filter Air filter
Hydraulic fluid tank, level Battery
Hydraulic fluid filter Recycling
Transmission, oil level Fuel filter
Drum, oil level Coolant, level
Oil for lubrication
CAUTION
CAUTION

Dynapac CA150D Specifications

General

Brand	Dynapac
Model	CA150D
Category	Construction Equipment
Language	English