16 CA 150 M150EN2
EVERY 50 OPERATING HOURS (Weekly)
Tires – tire pressure
Wheel nuts – tightening
Fig. 17 Wheels
1. Air valve
2. Wheel nut
1
2
Check the tire pressures using a pressure gauge.
If the tires are filled with fluid, the air valve (1) must be
in the “12 o’clock” position during pumping.
The relevant tire pressures are given under the heading
“Specifications”.
Check both tires.
When changing the tires it is important that
both of them have the same rolling radius. This
is necessary to ensure proper functioning of
the anti-slip in the rear axle.
Check the tightening torque of the wheel nuts (2) at 470
Nm (350 lbf.ft). Check both wheels and all the nuts.
(Applies only to new machine or recently fitted wheels.)
Check the safety manual that accompanies
the roller before filling the tires with air.
CAUTION
WARNING
To Next Page
Loading...
Need help?
General
