25CA 150 M150EN2
1
2
3
1
2
EVERY 2000 OPERATING HOURS (Every year)
Hydraulic tank
– Fluid change
Fig. 36 Hydraulic tank, underside
1. Drainage tap
2. Plug
Place the roller on a level surface. Switch the
engine off and push in the reserve/parking
brake knob for all checking and adjustments
on the roller, unless otherwise specified.
Danger of being burned when draining hot
oil. Protect your hands.
Obtain a container for collecting the used fluid. The con-
tainer should have a volume of at least 60 litres (16 gal).
A suitable container may be an empty oil drum or sim-
ilar item which is placed beside the roller. The fluid then
runs in a hose from the drainage plug (1) to the oil
drum, after the plug (2) has been removed and the tap
opened.
Save the oil and deposit it in an approved
manner.
Fill with fresh hydraulic fluid according to instructions
under the heading ”Hydraulic reservoir—checking the
level”. Change the hydraulic filter at the same time
Start the diesel engine and operate the various hydrau-
lic functions.
Make sure there is adequate ventilation
(extraction) if the diesel engine is run
indoors.
(Risk of carbon monoxide poisoning)
Check the fluid level and top up if necessary.
WARNING
WARNING
WARNING
Drum – Changing the Oil
Place the roller on a level surface so that the drain plug
(1) is straight down and place a receptacle that will hold
at least 15 liters under the plug.
Save the oil and deposit it in an approved
manner.
Clean and unscrew the plug (1). Allow all of the oil to
drain off. Fill with oil according to “Drum—checking the
oil level”.
There is danger of being scalded when
draining hot oil. Protect your hands.
WARNING
Fig. 37 Drum, right side
1. Drain/Filler plug
2. Number plate
3. Sight glass
To Next Page
Loading...
Need help?
General
