Dynon SkyView SE - Page 96

Messages and Alerts
9-10 SkyView SE Pilot’s User Guide - Revision I
Spoken Alert
(if configured)
Message Displayed in
Message Window
Visual Alert
(severity)
Description
"Caution"
MAG FACT CAL
CORRUPT
The Remote Magnetometer's
factory calibration is no longer
valid. Heading information is
unavailable. Contact Dynon
Avionics for assistance.
"Caution"
NEED COMPASS CAL
Magnetic compass heading in
either the ADAHRS or Remote
Magnetometer module is not
calibrated.
"Caution"
NEED USER AOA CAL
Angle of Attack (AoA) calibration
for the ADAHRS module has not
been performed.
"Caution"
OTHER DISPLAY OFFLINE
A SkyView display has failed or is
no longer communicating via
SkyView Network.
"Caution"
POSITION SOURCE #
FAIL
The identified position source has
failed.
"Caution"
ROTAX: LIMIT FLIGHT OP
The ROTAX engine has informed
SkyView there is a problem with
the engine.
"Caution"
ROTAX: LAND AIRCRAFT
The ROTAX engine has informed
the SkyView EMS-221 there is a
significant problem with the
engine.
"Caution"
TEMP HIGH – INCR RPM
The ROTAX engine coolant
temperature should be reduced
by increasing idle speed.
"Caution"
SOFTWARE MISMATCH
SkyView components are not all
running the same software
version.
"Caution"
STANDBY NETWORK
ERROR
SkyView Network has lost a
redundant network connection to
one or more system components.
See Standby Network Error
Explained section at end of this
table for more information.
"Caution"
TRIM SWITCH STUCK
The system has detected a wiring
fault in the trim button/switch.