EasyManua.ls Logo

E&P HYDRAULICS Level M System - About this Document; Contact Information; Declaration of Conformity

Default Icon
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ABOUT THIS DOCUMENT
Contact information
Retailer
Name E&P Hydraulics U.K. Ltd.
Address
Unit 10, Elder Court, Lions Drive
Blackburn, Lancashire, BB1 2EQ
England
Phone + 44 (0)1254 297785
E-mail info@ep-hydraulics.co.uk
Website www.ep-hydraulics.co.uk
Manufacturer
E-mail info@ep-hydraulics.com
Website www.ep-hydraulics.nl
Declaration of Conformity
0001 7
US
NOTICE:
This device complies with Part 15 of the FCC Rules [and contains license-exempt transmitter(s)/ receiver(s) that comply with Inno-
vation, Science and Economic Development Canada’s licence-exempt RSS standard(s)].
Operation is subject to the following two conditions:
this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Changes or modifications made to this equipment not expressly approved by E&P Hydraulics U.K. Ltd may void the FCC
authorization to operate this equipment.
NOTICE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructi-
ons, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
E&P HYDRAULICS
FCC ID
2A5AD-4100938
2A5AD-4100970

Table of Contents