PROFIBUS I/O Parameters
C441 PROFIBUS Module User Manual MN042002EN—July 2015 www.eaton.com 31
input 2 Trip Reason Bit Fault
0 = Overload trip
1 = Jam fault
2 = Stall fault
3 = Current Imbalance fault
4 = Load disconnect fault
5 = PhaseLoss fault
6 = Mains voltage fault
7 = Phase reversal fault
8 = Shorted scr fault
9 = SCR not firing fault
10 = Pole over temp fault
11 = Bypass dropout fault
12 = SCR over current fault
13 = Contactor over current fault
14 = Communications fault
15 = Device fault
input 20 Active Fault Code Last 10 fault codes
output 2 Motor Control 0x0001 Run
0x0004 Permissive
0x0008 reset
output 2 Command Register 1 = Clear Motor Run Hours,
2 = Clear Motor Start Count,
3 = Clear Fault Queue,
255 = Force Overload Rest (TP=0)
Note: Command register will clear after write
output 2 Configuration Reset 1 = Soft Reset
2 = Factory Defaults
Table 24. S611 Available IO Data for Cyclic Polling, continued
IO Size (in bytes) Configuration Modules Notes
To Next Page
Loading...
