Application Example: Operating a C441 Motor Insight with a Siemens PLC on PROFIBUS-DP
66 C441 PROFIBUS Module User Manual MN042002EN—July 2015 www.eaton.com
In the “Modify value” column for QB2 enter a 1 to energize Output1 and a 0 to de-energize
Output1. If the system is wired to the motor as described earlier in the document, when Output1 is
energized, the motor will Run.
The data can be entered/viewed in different formats by changing the Display Format for any value.
Each time values are entered or modified in the “Modify Value” column for the Outputs tag, the
lightning bolt with a 1 under it shown below must be selected to instruct the software and the PLC
to write the value to the C441 Motor Insight.
Refer to the PROFIBUS Chapter in the C441 Motor Insight User Manual (publication MN04209001E) for
additional information on the configuration, control and monitoring parameters, Fault Codes and more.
References
C441 Motor Insight User Manual, Publication MN04209001E
Additional Help
In the US or Canada: please contact the Technical Resource Center at 1-877-ETN-CARE
or 1-877-326-2273 option 2, option 6.
All other supporting documentation is located on the Eaton website at www.eaton.com/Drives
To Next Page
Loading...
Need help?
General
