Eaton i-on Series - Page 118

Installer Menu Options i-on Range
Page 108
Channel 6
Tamper
Channel 7
Confirmed Alarm
Channel 8
General Fault
Note: In EUR versions the default for Channel 5 is Zone Omit (setting).
Table 4a and 4b shows the events available. You can key-in the two-digit numbers shown
next to each event in order to display that event type on the keypad. Table 4a applies to
UK systems. Table 4b applies to EUR systems.
Table 4a. Fast Format Events (UK Systems)
00. Not used
12. Tamper (see note 6)
01. Fire Alarm
13. Open (see note 1)
02. Hold Up Alarm
14. Close (see note 1)
03. Burglar Alarm
15. Zone Omit - setting (see note 2)
04. Open/Close
16. Zone Omitted - system
05. Alarm Abort
17. General Fault
06. Technical Alarm
18. Masking
07. Confirmed Alarm
19. Duress Code
08. RF Low Battery
20. HUA Confirm
09. RF Supervision (see note 4)
21. Burg Confirm Alarm
10. RF Jamming (see note 4)
22. Burg Alarm P1 (partitioned system only)
11. Mains Fail (see note 5)
.. and so on up to the maximum number of
partitions handled by the control unit. For example
on an i-on160EX:
42. Burg Alarm P20 (partitioned system only)
Table 4b. Fast Format Events (EUR Systems)
00. Not used
10. RF Jamming (see note 4)
01. Fire Alarm
11. Mains Fail (see note 5)
02. Hold Up Alarm
12. Tamper
03. Burglar Alarm
13. Open (see note 1)
04. Open/Close
14. Close (see note 1)
05. Alarm Abort
15. Zone Omit - setting (see note 2)
06. Technical Alarm
16. General Fault
07. Confirmed Alarm
17. Masking
08. RF Low Battery
18. Duress Code
09. RF Supervision (see note 4)
19. Burg Alarm P1 (partitioned system only)
.. and so on up to the maximum number of
partitions handled by the control unit. For example
on an i-on160EX:
38. Burg Alarm P20 (partitioned system only)
Notes:
1. Open and Close provide the same functions as Open/Close, but on two separate
channels.
2. Zone Omitted - the control unit sends this signal for five seconds when a user omits
a zone.