Eaton i-on Series - Appendix IV: Programming a 762 or 768;769 as an Output Module; Introduction; Before You Begin; Set up the 762 or 768;769

i-on Range
Page 149
Appendix IV: Programming a 762 or 768/769 as an
Output Module
Introduction
Before You Begin
Carry out a radio site survey.
Set Up the 762 or 768/769
Enter Programming Mode
To enter programming for the first time (while installing a new unit):
1. Connect a suitable 12VDC power supply to the DC supply in
connector.
The display shows the version number of the software as two
alternating two-digit numbers, for example:
01 00
2. Press Select.
Ln
The display shows the first command in the menu: Manual Learn.
To enter programming while the unit is operating:
1. Open the 762r (or 768r/769r) case lid.
Note: If the unit is connected to an alarm control panel the tamper alarm
may sound.
The display is blank.
2. Press Select.
Ln
The display shows the first command in the menu: Manual Learn.
Set the Channels to Output Module Mode
Enter programming mode if the 762r or 768r/769r is not already there.
Ln
3. Press Select until the display shows the Output Mode command “OP”:
OP
4. Press Set.
The display shows the first channel number.
C1
5. Press Set again.
The display shows the channel’s current mode, for example:
n1
6. Press Select until the display shows “n6”, the Output Module Mode:
n6
7. Press Set.
The display shows the Output Mode command “OP” again:
OP
8. Press Set.
The display shows the first channel number:
C1