Appendix IV i-on Range
Page 152
1. Press Esc/Del to go back to the command menu.
The display shows: Ln
2. Press Select until the display shows the command "GO".
You should see: GO
3. Press Set.
The display shows: CL
You should hear a single beep repeated slowly.
4. Close the lid.
The unit is now out of programming mode.
Note: There is a deliberate delay of four seconds before the receiver leaves programming
mode. This is to make sure that you have time to close the lid properly and screw it
down firmly.
At the Keypad
11. Press .
The display shows the menu option that allows you to
name the radio output:
12. EITHER:
Press to carry on and program the output name.
OR: Press to carry on and program the output with
a type, make it latched, or give it an on and off time.
OR: Press to carry on with other programming.
DON’T FORGET to leave the Installer Menu in order to
save the changes you have made (see page 13 ).
To Next Page
Loading...
Need help?
General
