Eaton i-on Series - Page 120

Installer Menu Options i-on Range
Page 110
301
A/C power fail alarm (also called Mains fail) and restore
Mains Fail
302
Panel Battery low/fail and restore
Panel Battery
305
System or Partition reset
Reset
311
Panel Battery low/ missing and restore
Panel Battery
311
External battery fault and restore
Faults
320
Zone External Warning Device fault and restore
WAM trouble and restore
Faults
330
Bus device aux fuse fault and restore
Faults
337
Smoke/WAM psu fail and restore
RF Battery/PSU
337
Bus device low voltage fault and restore
External PSU fault and restore via zone n
Faults
338
Ext Siren/WAM low battery fail and restore
RF Battery/PSU
338
External PSU low volts via zone n
Faults
342
External PSU AC fail and restore
Faults
344
Jamming fail and restore*
RF Jamming
351
Comms line fault and restore
Faults
373
Smoke fault and restore
Faults
375
Zone HUD Fault and restore
Faults
380
Masking fault and restore
Burglar Alarm
Masking
381
Zone supervision fail and restore
Radio keypad supervision fail and restore
External siren supervision, fail and restore*
WAM supervision fail and restore
RF Supervision
384
Zone low battery fail and restore
RF Battery/PSU
389
4k4 Fault and restore on zone n
Faults
Masking
401
System or Partition set and unset
Set/Unset
401
System or Partition part set
Part Set
406
Alarm Abort
Burglar Alarm
409
System or Partition keyswitch set and unset
Set/Unset
409
System or Partition keyswitch part set
Part Set
412
Downloading successful
Downloading
457
Exit timeout and restore
Exit Timeout
461
Four wrong user codes (also called “User code tamper”
or “excess keys”)
Tampers
573
User/system zone omit. Zone omit restore.
Omit
625
Time and date reset
Time Date Reset
627
Installer mode start keypad (web)
Installer Mode
628
Installer mode end keypad (web)
Installer Mode
*Note:
1. The control unit communicates Jamming, Supervision when the system is unset.