Eaton i-on Series - Page 122

Installer Menu Options i-on Range
Page 112
PA, PR
Zone HUA (PA) and restore
Keypad HUA (PA), Keypad HUA (PA) restore
RF HUA (PA), RF HUA (PA) restore
Radio keypad HUA (PA), radio keypad HUA (PA)
restore
Hold Up Alarm
PT, PJ
Zone HUD fault and restore
Faults
RS
Downloading successful
Downloading
RU
Downloading failed
TA, TR
Keypad tamper and restore
Detector tamper and restore
Lid tamper and restore
Bell tamper and restore
Radio keypad tamper and restore
External siren tamper and restore
WAM tamper and restore
Tampers
TA, TR
WAM trouble and restore
Faults
UA, UR
Technical alarm and restore
Technical Alarm
XQ,HQ
Jamming fail and restore*
RF Jamming
XT, XR
Zone low battery fail and restore
RF Battery/PSU
YA, YH
Zone External Warning Device fault and restore
Fault
YM, YR
Control unit battery low/ missing and restore
Panel Battery
YM, YR
External battery fault and restore
Faults
YP, YQ
Smoke/WAM psu fail and restore
RF Battery/PSU
YP, YQ,
Fail and restore for: Aux 12V, Aux 14.4V, Bell 12V,
Bus 12V, System 12V
Faults
YT, YR
Ext Siren/WAM low battery fail and restore
RF Battery/PSU
YT, YR
Control unit battery low/fail and restore
Panel Battery
YT, YR
External PSU low volts via zone n
Faults
YW
System error
Faults
*Notes:
1. The control unit communicates Jamming, Supervision when the system is unset.
Restorals
When you enable a CID/SIA Report Group, or when you use Fast Format reporting, the
control unit sends the relevant telegram both when an event occurs, and when the
condition causing the event stops. The second transmission of the telegram is also called
a “restore”.
You can enable or disable restoral reporting by selecting Communications – ARC
Reporting – Restorals. The options available are:
Disabled
Restore off. The control unit does not communicate restores.
Enabled.
Restore on. The control unit does communicate restores.