Basic Programming Procedures i-on Range
Page 20
2. Press or to enable or disable the ABCD LEDs. The
character at the right of the display shows “” when the LEDs are
disabled and “” when the
LEDs are enabled. For example:
3. Leave local programming mode and save your changes (see
below).
To Change Backlight Settings
1. Enter Local Programming mode (see above)
2. Press . The display shows the current status of the backlight
LEDs, for example:
3. Press repeatedly to select one of the following:
Backlight timed ().
The backlight will glow for 12 seconds after the last keypress.
The action of the backlight depends on the programming of the
control unit (which must have Release 4.03 software or higher
installed).
4. Leave local programming mode and save your changes (see
below).
To Disable/Enable the Status OK LED
1. Enter Local Programming mode (see page 11)
2. Press repeatedly until the display shows:
3. Press repeatedly to select one of the following:
Status OK LED OFF ().
The green status LED under the navigation key is disabled, and
will not glow (this may be useful when the keypad is placed in
bedrooms that should be completely dark at night).
4. Leave local programming mode and save your changes (see
below).
To Disable/Enable the Status Fault LED
1. Enter Local Programming mode (see page 11)
2. Press repeatedly until the display shows::
3. Press repeatedly to select one of the following:
Status Fault LED OFF ().
The red Fault LED under the navigation key is disabled, and will
not glow for any fault reports.
4. Leave local programming mode and save your changes (see
below).
To Next Page
Loading...
